Motor: 383 Stroker, appx. 10.75:1 CR

-350c.i. block, 4 bolt 1pc Rear main (non-roller), bored .030
-Eagle cast steel crank (3.75" stroke)
-Eagle forged I-Beam rods (bushed for floating pistons)
-TRW forged flat top pistons, 2 valve reliefs w/ floating wrist pins
-Comp Cams XE274H: 230/236 @.050, .490"/.490" 110LSA
-Comp Cams lifters, timing chain and valve springs (spec'd to camshaft)
-Comp Camps 1.5 full roller rockers
-Prothane hardened motor mounts
-New stock water pump
-1LE A/C delete pulley
-JET electric fan switch
-190 thermo
-GMPP Vortec Heads, ported on exhaust side (For future nitrous plans), checked all clearances due to slightly high lift cam
-Holley Stealth Ram MPFI intake w/ 30# SVO injectors
-Stock TPI throttle body
-MegaSquirt II V3.0 ECU
-Custom USB tuning port
-Kirban billet aluminum AFPR
-8-pin HEI module for triggering MS
-MSD 6A, Blaster II coil, Taylor Spiro-Pro 8mm wires
-AEM UEGO Wideband 02
-Walbro 255lph HP fuel pump
-GMPP hi-torque mini starter
-Hedman shorties w/ modified Y-Pipe (cut for true single 3" outlet)
-Dynomax bullet racing muffler

Drivetrain/Suspension:
-LT1 T56 6 speed, steel 3-4 fork, carbon fiber blocker rings, billet synchro keys, brass shifter pads
-Stock Hurst shifter
-McLeod Street Twin Disc clutch setup
-Stock driveshaft w/ new heavy duty u-joints
-LS1 front brakes (calipers polished and powder coated candy red)
-Wilwood Adj. prop valve
-Sam Biondo line lock
-3.70 posi 9 bolt rear w/ PBRs (calipers powder coated candy red)
-T/A Performance rear end girdle
-16"x8" IROC wheels (polished spokes with black powder coat inside)
-TDS Wonderbar (red)

Interior:

-APC Racing seats (black)
-RJS camlock 5 point harnesses
-Full Autometer Gauges (Ultra Lite): O/P, W/T, Fuel level, Volt, 10k Tach, 160mph Speedo, all mounted on a custom powder coated diamond plate bezel
-Grant steering wheel
-15% tint all around
-CE 8pt roll bar (w/o door bars)
-A/C Delete
-New ACC carpet (82I Dove Grey)
-1LE heater box with controls
-IROC door panels

Misc:
-Installed shift light behind cig. lighter hole
-Fab'd front clear turn signal lamps
-Fully custom LED tail/turn/stop lights
-All wiring redone and hidden as much as possible
-Grille and tail lights from '92 Z28
-Re-carpeted center console
-Many more to come as I remember them!